Colville: (509) 684-2569

Republic: (509) 775-2878

Airway Heights: (509) 244 0846

Deer Park: (509) 276-5400

Wenatchee: (509) 775-2878

The Water Professionals

Well Drilling · Pumps · Water Treatment

Fogle Pump and Supply Inc.

Pump Systems

We Service All Makes & Models

Once your well has been drilled, the next step is to install an adequate pump system to transfer the water to your faucets. Our Pump specialists can help you to decide on the right system for your requirements according to the type of property it will be used for, as well as various other factors which play an important part in determining what kind of system would suit you best.

In-Depth Pump Systems Check

Is your pump system up to standard? If your pump turns on and off frequently, results in a higher power bill or is in need of tuning up, then the water professionals can come to your rescue! 


Our pump specialists will be more than happy to carry out a complete pump system check for you, taking into consideration things like voltage, amperage, pressure, capacitors and much more.

Scheduling an Onsite Consultation

Our representatives will schedule an on-site meeting before beginning to set up your pump system. We'll help design the best system to fit your needs and make sure the water line runs underground below the frost line, to prevent frozen pipes in the winter. We can also offer guidance on installing a pump house or an "In-Well" pressure tank. 

We Know Our Pumps

With so many new products on the market, it can be tricky to decide on which pump would best fit your needs. At Fogle Pump and Supply, we install over 1,000 pumps every year, including the largest 1200 GPM Irrigation pumps, solar powered pump systems and large centrifugal pumps, down to the smallest 1/16 HP pumps for water distillers. No job is too big or small for us, so just leave it in our experienced hands. 

Pump System Questions

  • How do I get water to my house?

    Once the well is completed, a Fogle Pump & Supply representative will call and schedule an on-site meeting to measure distances, check elevations and design the system that best fits your needs. A four-foot deep ditch will be required to lay the water line to the pressure tank location and/or the house or any frost-free hydrants. The same ditch can be utilized for the electrical line. At the time of installing the submersible pump, the pitiless adapter will be installed. This adapter allows the water line to be connected through the casing to the pipe in the well. This way the water line runs underground below the frost line, which prevents frozen pipes in the winter.

  • How do I know if I need a pump house?

    A pump house is completely up to the landowner. If there is room in the home, then the pressure tank and water conditioning equipment are better off in a clean, warm and dry environment. If not, then a pump house can be constructed next to the well site. A pump house is a good idea if water is required on site for building purposes or recreational uses. The main disadvantage of a pump house is heating it during the cold weather conditions. Another new option is installing an “in-well” pressure tank. These stainless steel tanks are only 5 inches in diameter and 6 feet long. They hang below the pitless adapter, replacing the need for a pump house.

  • What kind of pump do I need?

    The most popular is a four-inch submersible pump that is set 10-20 feet off of the bottom of the well and is sized according to depth and gallons per minute. The submersible is the most efficient and provides more volume and pressure than the jet style pump.

  • How long will it take to install my pump system?

    Most systems are installed in 2 or 3 phases involving 3 to 5 hours per phase. This is usually when the property is being developed and the building process only allows certain phases to be completed step by step. Some systems can be excavated, installed, backfilled and running in one day depending on permits and inspections.

  • How do I maintain my pump system?

    If the system is designed and installed correctly; maintenance is very minimal other than occasionally checking the pressure in the tank and on the system gauge. Preventative maintenance in the winter from freezing is a priority. System maintenance programs are offered through Fogle Pump & Supply's service department. 

  • Should I get my water tested?

    Yes, water should always be tested for potability. Local, county, and state agencies all require different tests in different areas for building and septic permits. Also, banks may require a potability test for loans. Bacteria, nitrate, lead, and arsenic tests are typically the minimum requirements in this area. Water should also be tested for minerals and hardness to protect pipes and appliances from premature failure.

Get in Touch with us Today at (800) 533-6518 for Your Pump System Estimate

Share by: